Install new 4 amp service wiring and grounding per nec via 3phase 3 amp panel board for 3 phase 2 volt 3 wire system; install new 1 amp service wiring and grounding per nec via 2 pole 1 amp panel for 1 phase 120/2 volt 3 wire service. As p

Install new service lateral and replocate 200a 3ph 240volt to exterior bldg; install new service lateral and relocate 100a 1ph 240/1 volt to exterior bldg. As per code.

New transformers and wiringfixtures new starters for equipment conduit & wiring breaker panel as per plans as per code.

New transformers and wiringfixtures new starters for equipment conduit & wiring breaker panel as per plansf as pfer code.

Install (1) 2 amp 3 delta 2 v service wms# 23967 as per code

5 security devices as per code

Replace missing service cable from 100amp 3 phase tenant panel inside space to metr on outside wall. As per code.

Use portion of premises k/a 6604 landay avenue as a ice cream warehouse

Install a new 2 amp 3 phase service as per code.

Install new gas line to new tee shirt dryer 3 0 btus. Gas meter upgrade needed. Install new 52 gallon electric water heater and laundry sink as per code.

Amend permit #com2012-173 issued on 08/17/2012 without plans to add the following additional work: change scope. Relocated existing cables. Relocate 2-4 seu cables for 4 amp service to new i-beam. Relocate 1-4 seu cable for 2 amp service to new

Remove service cable of building and relocate to new service i-beam 3-4 seu cables - 2 amps cable only as per code.

"amend permit #com2011-16355 issued on 8-16-11 with plans #2011-1107 to add the following additional work; increase initial feet of footer from 78"" to 96"" in diameter. Use of temporary casings as per plans as per code. Original permit description:(com201"

Relocate gas meter as per code

Remove and rebuild an existing double faced general outdoor advertising sign with a new double faced general outdoor advertising sign with an electronic screen on the west face. Upgrade existing electrical service to 120/2 volt single phase- 3 wire 200

Replacement of fire damaged exterior walls panels and framing. Replace fire damaged exterior doors. Provide exit access corridor and add restrooms. Provide hvac and electrical work. Work done to code and per plans.

Furnish and install 44 of 6 high wood stockade fence as per plans as per code.

Use for storage of electronics online sales and occasional local pick up

Interior work - (2) amp disconnect (2) amp disconnect and (1) 2 amp panel as per code.

Install fire alarm system with control panel in warehouse and showroom areas per approved plans per code.

Install low voltage security devices as per code

Amend permit#com2009-26452 issued on 1-7- with plans#2009-1484 to add the following additional work: revision to power and lighting plans as per plans as per code. Original permit description:(com2009-26452)interior renovation of an existing smoke damage

Amend permit #com2009-26452 issued on 01/06/ with plans #2009-1484 to add gas fitter contractor as listed above. Original permit description:(com2009-26452)interior renovation of an existing smoke damaged retailer. Construction to include new non-beari

Amend permit com2009-26452 issued on 01/06/ with plans #2009-1484 to add hvac contractor as listed above. Original permit description:(com2009-26452)interior renovation of an existing smoke damaged retailer. Construction to include new non-bearing exter

Interior work to replace waste and water and vent piping to reconstruct two toilets two lavatories and two 6-gallon electric hot water heaters as per code.

Amend permit # com2009-26452 issued on 01/06/ with plans# 2009-1484 to add contractor as listed above. Original permit description:(com2009-26452)interior renovation of an existing smoke damaged retailer. Construction to include new non-bearing exterior

Interior renovation of an existing smoke damaged retailer. Construction to include new non-bearing exterior wall new lights new acoustic paneled ceiling (apc) @ front sales area and existing restrooms new exterior doors new roof-top units (rtus) serv

(use)portion of the premises k/a 6502 for tire whole sale and storage .

Existing 4 amp to upgrade to 10 amp 2 volts 3 phase center phase ground. Add circuit for 2 amp for grinder. Install 225 kw transformer 2 to 480v transformer. As per code.

Install sign standing front of the building (non-illuminated) business identification 77. 6 sq ft two sided as per plans as per code.

(use) use portion of premises for the wholesale sales/storage of carpet and installation of same.

Existing 4 amp to upgrade to 10 amps 240volt 3 phase ctr ground. Add circuit 2 amp for grinder as per code.

Use portion k/a 824 a landay ave for contractor shop and yard (yard in rear) materials that are bouyant flammable explosive or that in times of flooding could be injurious to human animal or plant life shall not be stored below 1 foot above the 100--

Install new gas main to secure existing 2 0 and 1 0 btu unit heater. 1 of 1 1/4 blk steelnew gas meternew gas meter.

"install new gas main to secure existing 2 0 btu unit heater and a future 2 0 appliance 2 of 1 1/2"" blk. New gas meter."

Replace lights and fixtures install exit and emergency lights and install exterior lights. One existing meter.

120/2 heavy up one phase 120/2 heavy up three phase 240v three wire. Install new lights exists and emergency lights. Install exterior lights and circuits for equipment. Two new meters two enlarg meters.

Amend permit #com2009-26452 issued on 01/06/ with plans #2009-1484 to add gas fitter contractor as listed above. Original permit description:(com2009-26452)interior renovation of an existing smoke damaged retailer. Construction to include new non-bearing exterior wall new lights new acoustic paneled ceiling (apc) @ front sales area and existing restrooms new exterior doors new roof-top units (rtus) servicing for existing rtus removal of ceiling grid @ front sales area and infill of existing openings as per plans as per code.

Amend permit com2009-26452 issued on 01/06/ with plans #2009-1484 to add hvac contractor as listed above. Original permit description:(com2009-26452)interior renovation of an existing smoke damaged retailer. Construction to include new non-bearing exterior wall new lights new acoustic paneled ceiling (apc) @ front sales area and existing restrooms new exterior doors new roof-top units (rtus) servicing for existing rtus removal of ceiling grid @ front sales area and infill of existing openings as per plans as per code.

Amend permit#com2009-26452 issued on 1-7- with plans#2009-1484 to add the following additional work: revision to power and lighting plans as per plans as per code. Original permit description:(com2009-26452)interior renovation of an existing smoke damaged retailer. Construction to include new non-bearing exterior wall new lights new acoustic paneled ceiling (apc) @ front sales area and existing restrooms new exterior doors new roof-top units (rtus) servicing for existing rtus removal of ceiling grid @ front sales area and infill of existing openings as per plans as per code.

Interior renovation of an existing smoke damaged retailer. Construction to include new non-bearing exterior wall new lights new acoustic paneled ceiling (apc) @ front sales area and existing restrooms new exterior doors new roof-top units (rtus) servicing for existing rtus removal of ceiling grid @ front sales area and infill of existing openings as per plans as per code.

Amend permit # com2009-26452 issued on 01/06/ with plans# 2009-1484 to add contractor as listed above. Original permit description:(com2009-26452)interior renovation of an existing smoke damaged retailer. Construction to include new non-bearing exterior wall new lights new acoustic paneled ceiling (apc) @ front sales area and existing restrooms new exterior doors new roof-top units (rtus) servicing for existing rtus removal of ceiling grid @ front sales area and infill of existing openings as per plans as per code.

Amend permit #com2012-173 issued on 08/17/2012 without plans to add the following additional work: change scope. Relocated existing cables. Relocate 2-4 seu cables for 4 amp service to new i-beam. Relocate 1-4 seu cable for 2 amp service to new i-beam as per code. Original permit description:(com2012-17310)remove service cable of building and relocate to new service i-beam 3-4 seu cables - 2 amps cable only as per code.

Remove and rebuild an existing double faced general outdoor advertising sign with a new double faced general outdoor advertising sign with an electronic screen on the west face. Upgrade existing electrical service to 120/2 volt single phase- 3 wire 2 amps. Install two multi wire 2 volt circuits rated at amps or less and install one 1 volt circuit rated at amps for digital billboard and controls. As per plans as per code. Bmza decision 2011- freestanding sign with two 14 x 48 sign faces as per plans as per code.

Amend permit #com2011-16355 issued on 8-16-11 with plans #2011-1107 to add the following additional work; increase initial feet of footer from 78" to 96" in diameter. Use of temporary casings as per plans as per code. Original permit description:(com2011-16355)remove and rebuild an existing double faced general outdoor advertising sign with a new double faced general outdoor advertising sign with an electronic screen on the west face. Upgrade existing electrical service to 120/2 volt single phase- 3 wire 2 amps. Install two multi wire 2 volt circuits rated at amps or less and install one 1 volt circuit rated at amps for digital billboard and controls. As per plans as per code. Bmza decision 2011- freestanding sign with two 14 x 48 sign faces as per plans as per code.

Install new 4 amp service wiring and grounding per nec via 3phase 3 amp panel board for 3 phase 2 volt 3 wire system; install new 1 amp service wiring and grounding per nec via 2 pole 1 amp panel for 1 phase 120/2 volt 3 wire service. As per code.

Use portion k/a 824 a landay ave for contractor shop and yard (yard in rear) materials that are bouyant flammable explosive or that in times of flooding could be injurious to human animal or plant life shall not be stored below 1 foot above the 100--year flood level.

Install 1 amp 3 phase service.

Install new gas main to secure existing 2 0 btu unit heater and a future 2 0 appliance 2 of 1 1/2" blk. New gas meter.