Remove existing rear walls to access new addition. Demolish partial first floor at the rear (14-0x4-0) non-structural demo & removal of plaster drywall windows doors non-bearing walls roofing & floor material & removal of debris and equip. New second floor addition (14 x 9-0) supported by structural wing walls . New roof top deck (14-0"x20-0"). New interior framing & drywall (2x4studs at 16"o. C.) for 1st & 2nd floor. New 3-0" wide interior stairs (7. 75"max risers & 10" min. Treads) and hangers. New floor finishing new interior doors (10) new exterior doors (4) new windows(5) new sidings and new rubber roof over existing roof. Existing windows and doors same sizes and locations. New insulation (r49 for roof r21 for exterior walls). New concrete parking pad 252 s. F. As per plans as per code. (mech. Elect. And plumbing permits to obtain separately. Bmza approval number 2017-259

Non structural alterations: exterior work: remove form stone clean cut and point front as per code. Separate permit from dot required.

Underpinning of foundation walls as per attached engineers plans and certification. The engineer certification is required at completion of work and with a report of the exact dates of periodic inspections during the construction. Existing basement height = 6-0" proposed height = 8-0" as per drawing and as per code.

Install (1) # electric water heater (14) # plumbing fixtures (1) # sanitary connection (reconstructio (1) # water service pipe (reconstruction) (1) 910 btu fuel-burning equip (1) 460 btu fuel-burning equip (2) # fuel piping (1 or 2 family) as per code.

Install (1) 300 btu air-con system condensor (1) 700 btu fuel-burning equip(furnace) (1) # new distribution system (1-2 family) as per code.

Install (25) # branch circuits feeders (1) 2 amps electric service up to 600v (#amps) (6) # low voltage as per code.