Fixtures & devices 1-25

(use) - use the entire premises as a single-family dwelling

Reinstate permit com2006-24989 for thirty (30) days for final inspection. Original permit description:(com2006-24989)add a roof top deck 15 x change internal stair case. External stairs accesss in rear. Add a sump pump/ pit in the basement as per co

Original permit description:(com2006-32206)install new heat and a/c w/duct work as per code

Wiring of renovated house to include 4 hvac units 2 water heaters lights recepts telephone cable tv basic kitchen appliances. 200amp elect service. As per code.

Install new heat and a/c w/duct work as per code

Add a roof top deck 15 x change internal stair case. External stairs accesss in rear. Add a sump pump/ pit in the basement as per code.

Remove all non loade bearing interior partition walls and ceilings install framing ect. For a new interior layout to consist of three bedrooms three and a half bathrooms kitchen laundry room and den replace two exteriro door and windows as needed. In

"cut and remove four concrete squares surrounding the bldg; remove existing steps. Dig a footer 32"" deep reinforce w/rebar and have it inspected. Veneer existing bldg from the foundation to the roofline install new set of steps. Wash down using water only"

Build a fence 16linear ft at the end of the property abutting the alley. The fence will have a gate and will be built using 1x4x6ft tall segment of lumber. P&e completed fence should have the dimensions of 16ftx6ft w/a gate in the middle. As shown on diag

Reinstate permit com2006-24989 for thirty (30) days for final inspection. Original permit description:(com2006-24989)add a roof top deck 15 x change internal stair case. External stairs accesss in rear. Add a sump pump/ pit in the basement as per code.

Build a fence 16linear ft at the end of the property abutting the alley. The fence will have a gate and will be built using 1x4x6ft tall segment of lumber. P&e completed fence should have the dimensions of 16ftx6ft w/a gate in the middle. As shown on diagram and per code. Build 2 adjacent fence w/dimensions of 80x6ft along south & north side of property.

Cut and remove four concrete squares surrounding the bldg; remove existing steps. Dig a footer 32" deep reinforce w/rebar and have it inspected. Veneer existing bldg from the foundation to the roofline install new set of steps. Wash down using water only as per code.

Remove all non loade bearing interior partition walls and ceilings install framing ect. For a new interior layout to consist of three bedrooms three and a half bathrooms kitchen laundry room and den replace two exteriro door and windows as needed. Instll all water waste and gas piping for the plumbing fixtures as follows 4 water closets 2 showers 1 tub/shower 5 lavs kitchen sink dishwasher washing machine disposal 2 water heaters 1 stove/range 2 furnaces/dryer.

Non structural alterations exterior work - new rear concrete slab (4" concrete 4" gravel (14 x 37. 5) as per drawing code

Interior work: category 2 demo (500sqft) interior work (1375 sqft) non-earing stud walls plaster trim insulation flooring roofing & debris. New floor joists 2"x10" 16" o c per plans. New interior work: framing w 2"x4" 16" o c stud walls drywall trim insulation (r-20walls r-49 roof) inter doors (20). New exterior work: new 1st floor rear deck (3-4"x3) w staircase min 3 wide max riser tread to ex. Grade. New rooftop deck (14x14-6") w internal staircase. (min 36 wide 7 3 4 riser 11"tread). Replace exterior doors (3) windows (7) same size and location as per plans as per code.

Install (14) # plumbing fixtures (1) # electric water heater (1) # water service pipe (reconstruction) (1) # storm water connection (reconstruction) (1) 350 btu fuel-burning equip (1) 750 btu fuel-burning equip as per code.

Underpinning of foundation walls as per attached engineers plans and certification. The engineer certification is required at completion of work and with a report of the exact dates of periodic inspections during the construction. Existing basement height = 6-0" proposed height = 8-0".

Install (1) 720 btu fuel-burning equip (1) 300 btu air-con system heat pump (1) # new distribution system (1-2 family) as per code.

New 1 amp service. All new wiring. As per code. Ckts.

Use entire premises for a single family rowhouse dwelling.

Original permit description:(com2006-32206)install new heat and a c w duct work as per code

Reinstate permit com2006-24989 for thirty (30) days for final inspection. Original permit description:(com2006-24989)add a roof top deck 15 x change internal stair case. External stairs accesss in rear. Add a sump pump pit in the basement as per code.

Build a fence 16linear ft at the end of the property abutting the alley. The fence will have a gate and will be built using 1x4x6ft tall segment of lumber. P&e completed fence should have the dimensions of 16ftx6ft w a gate in the middle. As shown on diagram and per code. Build 2 adjacent fence w dimensions of 80x6ft along south & north side of property.

Cut and remove four concrete squares surrounding the bldg; remove existing steps. Dig a footer 32" deep reinforce w rebar and have it inspected. Veneer existing bldg from the foundation to the roofline install new set of steps. Wash down using water only as per code.

Remove all non loade bearing interior partition walls and ceilings install framing ect. For a new interior layout to consist of three bedrooms three and a half bathrooms kitchen laundry room and den replace two exteriro door and windows as needed. Instll all water waste and gas piping for the plumbing fixtures as follows 4 water closets 2 showers 1 tub shower 5 lavs kitchen sink dishwasher washing machine disposal 2 water heaters 1 stove range 2 furnaces dryer.

Install new heat and a c w duct work as per code

Add a roof top deck 15 x change internal stair case. External stairs accesss in rear. Add a sump pump pit in the basement as per code.