Interior work 1 438 sq. Ft. - non-structural demo and removal of plaster drywall windows doors non-bearing walls roofing and floor material & removal of debris and equipment. New interior framing and drywall (2 x 4 studs @ 16" o. C.) for first second and third floor and basement. New 3-0" wide interior stairs (7. 75" max risers and 10" min. Treads) & hangers. New floor finishing new interior doors (16). New insulation (r-49 for roof r21 for exterior walls). Exterior work - remove existing rear wall to access new addition. New 1st floor addition (2-6" x 30) 2nd floor addition (18-4" x & 2-6" x 34) 3rd floor addition (12-6" x 24) new rooftop deck (12-6" x 16). New exterior doors (3) new windows (12) new sidings and new rubber roof over existing roof. Existing windows and doors same size and locations. Replace rear concrete slab w/4" concrete and 4" gravel (202 sq. Ft.) as per drawing as per code.

Install 0 btu gas furnace 90% afue with a 36 0 btu 3-ton air conditioner 14 seer with all new duct system as per code. Electric & gas by others

Wire new townshouse and 25 ckts with 3 phone and 3 cable. Upgrade to a 2 amp service. As per code.

Structural alterations/interior work 292 sq ft - underpinning of foundation walls as per attached engineers plans and certification. The engineer certification is required at completion of work and with a report of the exact dates of periodic inspections during the construction. Existing basement height = 6-0" proposed height = 8-0". As per drawings/code.

Drains vents and water piping; gas piping per code; daul check valve; install 14 plumbing fixtures; electric water heater; gas furnace 91k water heater 63k stove 40k dryer 24k and fireplace 26k; reconstruct water and waste; as per code; hvac by others.

Tuck point existing brick as per code dot permit required

(use) use premises as a singlew-family dwelling.

Interior work 1 438 sq. Ft. - non-structural demo and removal of plaster drywall windows doors non-bearing walls roofing and floor material & removal of debris and equipment. New interior framing and drywall (2 x 4 studs @ 16" o. C.) for first second and third floor and basement. New 3-0" wide interior stairs (7. 75" max risers and 10" min. Treads) & hangers. New floor finishing new interior doors (16). New insulation (r-49 for roof r21 for exterior walls). Exterior work - remove existing rear wall to access new addition. New 1st floor addition (2-6" x 30) 2nd floor addition (18-4" x & 2-6" x 34) 3rd floor addition (12-6" x 24) new rooftop deck (12-6" x 16). New exterior doors (3) new windows (12) new sidings and new rubber roof over existing roof. Existing windows and doors same size and locations. Replace rear concrete slab w 4" concrete and 4" gravel (202 sq. Ft.) as per drawing as per code.

Extend original permit.(original permit:com2016-14608:interior work 1 438 sq. Ft. - non-structural demo and removal of plaster drywall windows doors non-bearing walls roofing and floor material & removal of debris and equipment. New interior framing and drywall (2 x 4 studs @ 16" o. C.) for first second and third floor and basement. New 3-0" wide interior stairs (7. 75" max risers and 10" min. Treads) & hangers. New floor finishing new interior doors (16). New insulation (r-49 for roof r21 for exterior walls). Exterior work - remove existing rear wall to access new addition. New 1st floor addition (2-6" x 30) 2nd floor addition (18-4" x & 2-6" x 34) 3rd floor addition (12-6" x 24) new rooftop deck (12-6" x 16). New exterior doors (3) new windows (12) new sidings and new rubber roof over existing roof. Existing windows and doors same size and locations. Replace rear concrete slab w 4" concrete and 4" gravel (202 sq. Ft.) as per drawing as per code. )original permit description:(com2016-14

Structural alterations interior work 292 sq ft - underpinning of foundation walls as per attached engineers plans and certification. The engineer certification is required at completion of work and with a report of the exact dates of periodic inspections during the construction. Existing basement height = 6-0" proposed height = 8-0". As per drawings code.