For the installation of a new hvac system with associated duct work and twenty-five (25) registers diffusers (2nd floor), per approved plans. Separate permit required for electrical, plumbing, fire suppression.

For erection of one double face internally illuminated projecting sign use as (accessory ) an existing building name. Use: vacant structure (use registration permit required prior to occupancy). Size and location as shown on the application.

Installation of wet checmical commercial kitchen hood fire suppression system with foryt-nine (49) flow points in accordance with nfpa 17a. See permit # 394332 for hood approval.

New commissary- new kitchen and bathrooms ,new water svc,new drains and water lines-install new kitchen and bathroom fixtures,new water heater,new grease trap. Pa1#201299999999

Install 400amp 480v svc,install transformer and 225amp 120 208v sub panel. Install wiring for equiptment,inside light fixtures and sw. Install outlets as required as per 2008 nec

Closure in place of (1) 80 gallon underground storage tank as per site plan.

Installing new fire alarm devices as per 2008 nec & nfpa72 necessary wiring on 1st fl restaurant area as per 2008 nec

Interior demolition non-load bearing partitions only(commercial)

Tco to operate phase 1 of the commissary

100 square feet, interior demolition on 2nd & 3rd floors of non load bearing walls and ceilings only. No other work allowed under this permit. No structural changes. Must maintain all code required fire rating on wall and floor ceiling assemblies. Three sets of plans drawn to professional quality are to be submitted for review and approval by the department before work on renovation starts. Contact streets department for dumpster permit and footway closure permits.

Rough in drain lines and vent line 2wc 2lavs 1 pantry sink - the installation will compy with the philadelphia plumbing code 2004

For alterations to the second & third floor exterior of an existing structure. Work to include repairs to masonry, installation of new canopy, and minor structural work. All asbesots to be treated & removed prior to commecement of work.

Commercial kitchen exhaust system: to include an array of four type 1 hoods and make-up air ductwork and one dishwasher hood

Hvac system and associated ductwork, piping & grds as per plans

Demo 80 sq ft of non bearing interior partitions

Remove and relocate devices from old walls into new walls on existing fire alarm system 8 smoke detectors, 3 pull stations, 1 duct detector, 9 horn strobes. Using existing fire alarm panel and circuits. Add a 2 amp 3 phase panel as per 2008 nec (cc district)

Removal of front metal cladding to expose exsiting masonry ext wall (removal to be by hand with streets dept closure as required)

Level ii interior alterations to existing second and third floors to create shell spaces and common corridors as per approved plans. Existing building not sprinklered (may be required under tenant fit-outs). Separate use registration and fit-out building permits required prior to occupancy of new spaces. Separate permits required for any mep work