Demolition permit

Electrical permit

Alteration permit

Zoning/use permit

Alteration permit

Permit for for the new construction of an attached structure with roof deck above rear third floor roof; size and location as shown in the submitted plan/application; for use as one commercial space (use registration required prior to occupancy) on the first floor and three dwelling units on the second through fourth floors.

Demolition permit

Alteration permit

Zoning use permit

Electrical permit

Alteration permit

Permit for for the new construction of an attached structure with roof deck above rear third floor roof; size and location as shown in the submitted plan application; for use as one commercial space (use registration required prior to occupancy) on the first floor and three dwelling units on the second through fourth floors.

For the erection of an attached structure height 33. 1 ft) with cellar, and an accessory roof deck for residential use only (guard rails 42" high) with roof access pilothouse (pilothouse contain stairs and landing only; maximum height ft. Roof deck set back at least five ft from the extreme front building line). Size and location as shown in the application. Uses - for vacant commercial space on first floor (must occupy 100% of the ground floor frontage with a minimum depth of 30) (uses only permitted in cmx-2 that not to require off street parking as per table 14-802-2, use registration permit is required prior to occupancy) and household living two (2) family dwelling units (on 2nd and 3rd floors). No sign on this permit

Stucco front,side & rear walls

Stucco building and add new windows on second floor. Work being done by owner, no employees. Stucco_-_exterior plaster. Installation of these materials shall be in compliance with astmc926 and astmc1063 and the provisions of this code. R703. 6. 1 lath. All lath and lath attachments shall be of corrosion- resistant materials. Expanded metal or woven wire lath shall be attached with 1-1 2-inch-long (38 mm), 11 gage nails having a 7 16-inch (11. 1 mm) head, or 7 8-inch-long (22. 2 mm), 16 gage staples, spaced at no more than 6 inches (152 mm), or as otherwise approved. Contact inspector at district office for wall inspection prior to starting work.